New Wing

Its time to catch up on the driver side wing removed in June. Here you see the trumpet section and attachment points for the wing painted with POR-15 rust paint. The splash panel was replaced behind the wheel. The front valence was quite a mess indeed. Here it is stripped down and in the process of bumping the metal back into shape. I learned some important body work lessens here. Patience is key! If you think it is smooth - its not. Keep going until you are absolutely positive you can get it no better. Extra work here saves time ten-fold during the later application of filler,which should be no more than a skim if you did it right.
I made this improvised "slap hammer" for final smoothing. Its a large spike welded to some thick flat stock and works nicely during the final smoothing stages. I would have preferred a more comfortable handle, but its what I had on hand at the time. A great book on the subject of metal body work is "The Key to Metal Bumping" available from Eastwood. The book is a classic from the 1950's and details the almost lost art of car body metal work.
Its a wing in a box!
Good things come by freight in large packages, like the heritage panel from Moss Motors made with the original tooling. In the packing materials I found a new electrical bullet connector. Spend several hundred dollars on a new wing, get a free bullet connector? The savings count well into the tenths of dollars.
Installation was a bolt-on operation with some minor adjustments for fit around the door and bonnet. Seam sealer at the joint by the window and some primer sealer completed the job. I also painted around the base of the window by the wipers due to considerable chipping and rust. Before and after pics:
No electrics in the wing yet. There are other priorities, including stabilizing the rust damage in the floor pans and other winter preparations.